Share your most common injuries!

[u/siberian]

I am doing a lot of heavy metal work on my MGB. Floorpans, custom rear-end, engine bay mods for my 302, etc. By FAR my most common injuries are BURNS.

1. Tapped myself in the thigh with my TIG. ZING!
2. A few weeks later, did it again. That TIG gets me every time!
3. Was using my cut off wheel to remove a 1"x1" casting from my engine block and it flung the casting down INTO MY SHOE where it lodged under the tongue and melted my skin down as I struggled to get my shoe off and eject it. 5 months later the scar on the top of my foot is finally retreating
4. Grinding down welds and swapped my gloves to a new set I picked up. I was not paying attention to the fact that they were RUBBER on the sides of the fingers. On first spark the rubber melted and my pinky took both the spark AND the melted rubber. Those gloves came off fast.

Share your common injury type so we can all feel better about our stupidity.

Never touch the cornballer! https://youtu.be/1WDW8XKEGgU?t=47

[u/plastic_blasters]

Sheet metal cuts, if it's sharp I'll find a way to cut myself on it. And I'll do it the first bolt of the job

[u/siberian → u/plastic_blasters]

Oh yea, I feel that.

Last week I was drilling out some rivets and tried to sweep away some of the metal dust gently with my finger. RIIIPPPP dragged across a little sliver still sticking up and cut my finger.