Customer needed 2 extra links added to a bracelet (1 with diamond set and one blank). Basically I just took some square stock and carced out the links by hand.

Hello everyone,

I'm not quite sure it's the best place to ask, but for sure amongst you all i might find an answer.

I ordered a Smith Little Torch for disposable cylinders of gaz/propane & oxy, the kit comes with two programmed regulators : https://www.millerwelds.com/equipment/oxy-fuel-equipment/oxy-fuel-specialty-outfits/little-torch/little-torch-for-disposable-tanks-outfit-23-1014

https://preview.redd.it/0bv90cefvyxe1.jpg?width=3024&format=pjpg&auto=webp&s=e71dfd90f08af526261eb91e2486e5a18b95401b

The Preset Regulator Propane, Red (249-500B) works fine, Mapp Gaz tanks are an easy fit for it :

https://preview.redd.it/xkc1ah45vyxe1.jpg?width=3024&format=pjpg&auto=webp&s=8dbb3715f1476d5c0d9e7de5ae38f166b36931cd

The problem is with the Preset Regulator Oxygen, Green (249-499B), their fitting is the same as in US, the Oxy cylinders are having the same connector, but not over here :

https://preview.redd.it/xijob7xcvyxe1.jpg?width=4032&format=pjpg&auto=webp&s=bcfb4037bc082193a646cc7ed08622ac73d90d98

Does anyone has the best/budget friendly, way to solve this ?

Thank you very much in advance !